8/16/2023 0 Comments Controlplane mac![]() ![]() In 20 SPB was used to build the InteropNet backbone with only one-tenth the resources of prior years. In May 2013, the first public multi-vendor interoperability was demonstrated as SPB served as the backbone for Interop 2013 in Las Vegas. ![]() In March 2012 the IEEE approved the 802.1aq standard. On 4 March 2006 the working group posted 802.1aq draft 0.1. The control plane is based on the Intermediate System to Intermediate System (IS-IS) routing protocol, leveraging a small number of extensions defined in RFC 6329. Unicast, multicast, and broadcast are supported and all routing is on symmetric shortest paths. Packets are encapsulated at the edge either in MAC-in-MAC per IEEE 802.1ah or tagged per IEEE 802.1Q or IEEE 802.1ad and transported only to other members of VLAN. The technology provides VLANs on native Ethernet infrastructures using a link-state protocol to advertise both topology and VLAN membership. It is designed to preserve the plug-and-play nature that established Ethernet as the de facto protocol at layer 2. ![]() These block any redundant paths that can result in a switching loop, whereas SPB allows all paths to be active with multiple equal-cost paths, provides much larger layer-2 topologies, supports faster convergence times, and improves the efficiency by allowing traffic to load share across all paths of a mesh network. SPB is designed to replace the older spanning tree protocols: IEEE 802.1D STP, IEEE 802.1w RSTP, and IEEE 802.1s MSTP. This technology is intended to simplify the creation and configuration of Ethernet networks while enabling multipath routing. IEEE 802.1aq is an amendment to the IEEE 802.1Q networking standard which adds support for Shortest Path Bridging ( SPB). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |